Patching Clamp: Lightweight, machined aluminum clamp for gluing cleats on violin or viola. Tightening screws on top and bottom swivel. 20mm mouth x 105mm throat. Made in USA.
Three-way Clamp: Lightweight machined aluminum clamp for re-gluing top or back on violin or viola. Swiveling tightening screws on top and bottom. Side screw used
to properly position instrument to prevent bulging ribs. Made in USA.
Edge CrackClamp: Draws together top or back crack, at edge, for gluing. Made in USA.
Endpin Rib Clamp: For re-gluing loose ribs to the lower block without opening the
instrument. After the pivot is inserted through the end pin hole, the
rods turns by gravity into the cross position. Sizes: Violin/Viola; Cello. Made in Germany.
Rib Corner Clamp: For re-gluing rib corners. Attach to rib corner area and apply pressure to each rib with perpendicular spindles. Sizes: Violin/Viola; Cello. Made in Germany.
Fingerboard Strap Clamp: Made of high strength plastic. Made in USA.
Hand forged steel clamps of high stability and low weight give well defined pressure. High pitch rods for fast closing action. Freely mobile brass swivels on ball bearings. All parts galvanized or made of corrosion free material. Available in following sizes: Throat measurement first, 40x30 mm, 85x40 mm, 135x45 mm, 160x40 mm,
German made gluing clamps. The pads of these clamps go over the edge of the instrument, directly over the rib, which eliminates possible chipping of varnish or damage to the edge. The materials used are glue repelling, non-aging and elastic to avoid leaving pressure marks.
Clamps colored to designate placement on instrument: Red = Corner Yellow = Inner Bouts Blue = Outer Bouts
Light, torsion-resistant clamp made of hammer finished, cast aluminum. Off-set base, steel screw and ball-jointed swivel pad. Available in following sizes: throat measurement first, 90x35mm, 120x40mm. 160x40mm, 200x50mm.