Patching Clamp: Lightweight, machined aluminum clamp for gluing cleats on violin or viola. Tightening screws on top and bottom swivel. 20mm mouth x 105mm throat. Made in USA.
Three-way Clamp: Lightweight machined aluminum clamp for re-gluing top or back on violin or viola. Swiveling tightening screws on top and bottom. Side screw used
to properly position instrument to prevent bulging ribs. Made in USA.
Edge CrackClamp: Draws together top or back crack, at edge, for gluing. Made in USA.
Endpin Rib Clamp: For re-gluing loose ribs to the lower block without opening the
instrument. After the pivot is inserted through the end pin hole, the
rods turns by gravity into the cross position. Sizes: Violin/Viola; Cello. Made in Germany.
Rib Corner Clamp: For re-gluing rib corners. Attach to rib corner area and apply pressure to each rib with perpendicular spindles. Sizes: Violin/Viola; Cello. Made in Germany.
Fingerboard Strap Clamp: Made of high strength plastic. Made in USA.
Wooden Peg Sets include 4 pegs for cello set, and 4 pegs and endbutton for violin and viola sets.
Ebony with Ebony Pin and Collar: Vla; Cello. Boxwood with Ebony Pin and Collar: Vln; Vla. Ebony with Boxwood Pin and Collar: Vln; Vla; Cello. Ebony Heart with Boxwood Pin and Collar: Vln. Ebony Heart with Ebony Pin and Collar: Vln; Vla; Cello. Boxwood Heart with Ebony Pin and Collar: Vln; Vla; Cello.
Hand forged steel clamps of high stability and low weight give well defined pressure. High pitch rods for fast closing action. Freely mobile brass swivels on ball bearings. All parts galvanized or made of corrosion free material.
Available in following sizes: Throat measurement first, 40x30 mm, 85x40 mm, 135x45 mm,
Composite pegs feature sealed gears within peg mechanism, creating
non-slip, non-stick, effortless tuning. Peg shaft at pegbox wall stays
in place while tuning is done with peg head, preventing peg/pegbox
friction. This helps eliminate effects of humidity and climate changes.
Professional installation suggested. For instructions, visit