Patching Clamp: Lightweight, machined aluminum clamp for gluing cleats on violin or viola. Tightening screws on top and bottom swivel. 20mm mouth x 105mm throat. Made in USA.
Three-way Clamp: Lightweight machined aluminum clamp for re-gluing top or back on violin or viola. Swiveling tightening screws on top and bottom. Side screw used
to properly position instrument to prevent bulging ribs. Made in USA.
Edge CrackClamp: Draws together top or back crack, at edge, for gluing. Made in USA.
Endpin Rib Clamp: For re-gluing loose ribs to the lower block without opening the
instrument. After the pivot is inserted through the end pin hole, the
rods turns by gravity into the cross position. Sizes: Violin/Viola; Cello. Made in Germany.
Rib Corner Clamp: For re-gluing rib corners. Attach to rib corner area and apply pressure to each rib with perpendicular spindles. Sizes: Violin/Viola; Cello. Made in Germany.
Fingerboard Strap Clamp: Made of high strength plastic. Made in USA.
The Juzek brand, comprises a set of four joining clamps. Sizes: 4 piece set for Vln/Vla; and 4 piece set for Cello.
The Herdim crack clamps have rotating pads with convex and concave sides adapt to
contour of instrument. Self-adjusting pressure pads bring sides of
crack even. Double rod for high strength and flexibility. Sizes: 280mm, Violin/Viola; and 180mm, for Violin/Viola.
Hand forged steel clamps of high stability and low weight give well defined pressure. High pitch rods for fast closing action. Freely mobile brass swivels on ball bearings. All parts galvanized or made of corrosion free material. Available in following sizes: Throat measurement first, 40x30 mm, 85x40 mm, 135x45 mm, 160x40 mm,
Light, torsion-resistant clamp made of hammer finished, cast aluminum. Off-set base, steel screw and ball-jointed swivel pad. Available in following sizes: throat measurement first, 90x35mm, 120x40mm. 160x40mm, 200x50mm.